Yeoman and servicing Manual de instrucciones descargar pdf (Pagina 19)

INSTALLATION INSTRUCTIONS

INSTALLATION

NOTE: For Top Exit appliances the flue collar must be

placed on the flue exit before the top is fitted.

3.2 To fit the top line up the raised fins on the underside of the

glass plate with the cut outs in the top of the box, see

Diagram 6.

AR2703

AR2692

Rear Exit

Top Exit

Fins

Cut Outs

Offset edge to

rear

Fins

AR2696

3.2 When properly fitted the rear of the glass plate should sit

flush with the rear of the appliance, see Diagram 7.

AR2695

2.5 Remove the bracket and drill the guide holes.

2.6 Fix the bracket either to the hearth or the bench, see

Diagram 3.

NOTE: Use the wood screws and rawl plugs in the fixing

kit supplied for hearth mounting installations and the

self tapping screws for installation onto a bench.

2.7 Lift the appliance so as to locate the key slots in the carcass

onto the fixing screws. There are two large holes the lower

flanges on the front edges of the base, see Diagram 4.

AR2688

Wingnut

Washer

Key slots

2.8 Place the two large washers over the studs and fix with two

wingnuts, see Diagram 4.

2.9 Connect the gas to the 8mm elbow located on the right

hand side under the firebox, Diagram 5.

AR2698

3. FITTING THE TOP PLATE

3.1 The Yeoman CL has a decorative plate that sits on top of

the outer box. Depending on the choice of flue exit this top

will have a hole for the flue pipe to pass through or be

completely smooth.

The hole will be situated in an off set position to the rear

edge of the cast top.

When installing the spigot must be put in place before the

cast top is located. Then the connection to the flue can be

made.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Comentarios a estos manuales

Sin comentarios

Yeoman and servicing Manual de instrucciones Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Cocinas Yeoman and servicing