
26
7. COMPLETION OF ASSEMBLY
7.1 To fit the window frame:
Offer the frame to the foot of the opening and secure using
8 screws as shown, Diagram 28.
28
AR2697
7.2 Fit the front and the plinth by inserting the hooks on the
back of the frame into the slots on the front of the
appliance, See Diagram 29 & 30.
29
AR2694
30
AR2693
7.3 Attach the door handle.
8. OPERATING THE APPLIANCE
IMPORTANT - THE CONTROL SYSTEM HAS BEEN
PROGRAMMED TO OPERATE ON CHANNEL 'A'. IN
SOME INSTANCES MULTIPLE HOUSEHOLD APPLIANCES
MAY HAVE ALSO BEEN SET TO OPERATE ON THE SAME
CHANNEL. ALTHOUGH THIS HAS NO EFFECT ON THE
SAFETY OF THE SYSTEM YOU MAY ENCOUNTER AN
EXCESSIVE DELAY BETWEEN COMMANDS. IF THIS
OCCURS PLEASE FOLLOW THE INSTRUCTIONS IN
INSTALLATION INSTRUCTIONS, COMMISSIONING,
SECTION 3 TO CHANGE THE CHANNEL.
The remote control handset has been factory set to only
communicate with the appliance it is supplied with. The
appliance will not respond to any other remote control,
even one from an identical appliance.
Note: In the event of a replacement handset being
acquired, pairing of the handset with the appliance will
need to be carried out. Please refer to Commissioning,
Section 2, Pairing Handset on page 29.
The appliance can be operated in two ways:
— Using the remote control handset.
— Using the touch pad control on the appliance.
The appliance has four flame settings which can be
controlled manually or automatically via temperature
sensing:
1. High (Pilot lit and main burner lit at the highest
flame setting).
2. Med (Pilot lit and main burner lit at the medium
flame setting).
3. Low (Pilot lit and main burner lit at the minimum flame
setting).
4. Standby (Pilot only).
31
AR2516a
On/Off
Button
Up
Button
Down
Button
INSTALLATION INSTRUCTIONS
INSTALLATION
Comentarios a estos manuales