Yeoman and servicing Manual de instrucciones Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 44
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
29
1. COMMISSIONING THE APPLIANCE
1.1 Complete the Commissioning Checklist at the front of this
manual covering:
— Flue checks
— Gas checks
— Log layout - flame picture
For working pressure test, use the access panel at the gas
connection ensuring the burner is in position. Refer to
Installation Instructions, Section 3.
1.2 Upon completion of of the commissioning and testing of the
installation and correct operation of the appliance, the
installer must instruct the user how to operate the
appliance.
1.3 Guide the user through the User Instructions paying
particular attention to:
a) Regular servicing (Section 10 of the User Instructions).
b) Ventilation (Section 11 of the User Instructions) - point
out the ventilation positions where applicable.
c) Hot surfaces (Section 13 of the User Instructions).
d) How the appliance works with the touch pad control
(Section 2B of the User Instructions).
e) How the appliance works with the remote control
handset and the modes of operation (Section 2A of the User
Instructions).
g) What to do if the appliance fails to operate (Section 14 of
the User Instructions).
2. PAIRING THE HANDSET WITH THE
APPLIANCE
Prior to re-connection of the control box to the appliance, if
there is no communication between the remote handset
and the appliance, or if the handset is replaced, it will be
necessary to pair the (new) handset with the appliance.
2.1 Remove the 2 x screws securing the control box bracket.
1
AR2698
Screws
2.2 Ensure batteries are fitted and working in the handset.
2.3 Ensure all leads and cables are connected correctly.
2.4 Press the On/Off button () for at least 10 seconds. The
LED will flash on and off as normal during this time. When
the LED on the control lights up for at least 1 second
release the button.
2.5 Within 5 seconds of the LED going out press the () button
followed directly by the () button.
2.6 Within 20 seconds press the yellow button on the control
box (see Diagram 2). This may be easier using a pencil, ball
point pen or similar.
2
AR2510
Remote Handset
Pairing Button
2.7 The control box will beep to confirm the pairing operation
has been successful.
INSTALLATION INSTRUCTIONS
COMMISSIONING
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Comentarios a estos manuales

Sin comentarios